Digigram CANCUN 442-Mic User Manual download pdf (Page 14)

Click on to set the parameters of audio inputs.

Each slider allows adjusting the analog gain for an analog input from

0dB to + 55 dB, by 1 dB steps.

It is possible to adjust the level of several inputs at the same time, by

moving only one slider. To do so, press “Shift + Click” on each slider.

The cursor of the slider becomes purple. When all the selected sliders

are purple, just move one of them. All the sliders move at the same

time

The vu-meters display the signal level after the analog to digital

conversion. The peak-meter instantaneous value is displayed right

above the vu-meter.

To mute an input, click on the corresponding Mute icon . Mute is

ON when icon is red .

Input pad and 48V phantom power

Click on the icon on the top left of the ANALOG panel to

display the panel allowing to set Pad and 48V on the inputs.

Pad is a fixed attenuator stage (-30 dB) available on each

input, that can be enabled/disabled.

To enable the Pad on an input channel, click on the OFF

button on the right of PAD for the selected channel.

When Pad is enabled on a channel, the button is displayed as

follows:

Audio alignment when Pad is OFF.

Alignment when slider is set to 0 dB: -5.2 dBu -> 0dBfs

Alignment when slider set to 55 dB: -60.2 dBu -> 0dBfs

Audio alignment when Pad is ON.

Alignment when slider is set to 0 dB: +25.6 dBu -> 0dBfs

Alignment when slider set to 55 dB: -29.4 dBu -> 0dBfs

Set Pad to OFF when using microphones.

When using static microphones, it is necessary to enable the

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 32 33

No comments

Digigram CANCUN 442-Mic User Manual Page 14